Table of contents
- What is 80 PLUS certification and how does it work?
- What 80 PLUS tiers exist and what does each require in Europe?
- How much money does an efficient PSU really save?
- What are the differences between voluntary certifications and mandatory markings?
- Key technical criteria before choosing a PSU
- Common mistakes when buying a power supply
- Which power supply should you choose based on your usage profile?
- FAQs about 80 PLUS and power supplies
What is 80 PLUS certification and how does it work?
The 80 PLUS programme, administered by the independent body CLEAResult, evaluates the energy performance of non-redundant internal power supplies at three specific load points: at 20% load, at 50% load and at 100% load (with the exception of the Titanium tier, which adds a measurement at 10% load). To pass the tests, the unit must maintain a minimum efficiency of 80% and record a power factor of 0.9 or higher at the tested loads.
Energy efficiency measures the ratio between the power that the power supply delivers to the system's components (motherboard, graphics card, processor) and the actual power it draws from the wall socket. If a computer demands 400 W under continuous load and the PSU operates at 80% efficiency, the energy drawn from the socket is 500 W, with 100 W dissipated directly as heat inside the case.
What 80 PLUS tiers exist and what does each require in Europe?
The European mains grid operates at a nominal voltage of 230 V, where power supplies achieve between 1% and 2% better performance than on 115 V grids owing to lower current-related losses. Manufacturers selling in Europe must have their models certified under the 230V EU Internal standard.
| 80 PLUS certification tier | Efficiency at 10% load | Efficiency at 20% load | Efficiency at 50% load | Efficiency at 100% load |
|---|---|---|---|---|
| 80 PLUS Standard | Not tested | 82% | 85% | 82% |
| 80 PLUS Bronze | Not tested | 85% | 88% | 85% |
| 80 PLUS Silver | Not tested | 87% | 90% | 87% |
| 80 PLUS Gold | Not tested | 90% | 92% | 89% |
| 80 PLUS Platinum | Not tested | 92% | 94% | 90% |
| 80 PLUS Titanium | 90% | 94% | 96% | 91% |
The 80 PLUS Silver certification has a residual presence in today's market, as most commercial designs jump straight from the Bronze tier to Gold. It is essential to remember that this label measures energy efficiency only at static load points; it does not guarantee voltage rail stability, electrical ripple or the quality of the internal components.
How much money does an efficient PSU really save?
The economic savings of a certified power supply depend on three factors: the power consumed by the hardware, the number of hours it runs per year and the cost per kilowatt-hour (€/kWh) billed by your electricity supplier.
For example, a desktop computer drawing a sustained 350 W with an old generic PSU at 75% efficiency draws 350 W / 0.75 = 466.6 W from the wall, whereas with an 80 PLUS Gold PSU at 92% efficiency it draws 350 W / 0.92 = 380.4 W, giving a direct difference of 466.6 W - 380.4 W = 86.2 W which, over intensive use of 2,000 h per year at an electricity price of €0.18/kWh, generates a consumption of 86.2 W × 2,000 h = 172.4 kWh and a net saving of 172.4 kWh × €0.18 = €31.03 per year.
Over a 5-year service life, the accumulated saving reaches €155.15, fully recouping the price premium of a higher-efficiency PSU over a basic one.
What are the differences between voluntary certifications and mandatory markings?
It is easy to confuse legal requirements for placing products on the market with technical accreditations of quality or efficiency:
- Mandatory legal markings in the European Union:
- CE: The manufacturer's declaration of conformity with EU directives. It is not a quality certification and is not issued by independent laboratories.
- RoHS: A directive restricting the use of hazardous substances (such as lead or cadmium) in electronic components.
- WEEE: Regulations governing the management and recycling of electronic waste.
- Voluntary technical certifications:
- 80 PLUS: An energy efficiency audit administered by CLEAResult.
- TÜV Rheinland: Verification of electrical safety and thermal insulation through independent laboratory testing.
- Cybenetics (ETA and LAMBDA): Voluntary programmes that analyse overall efficiency across thousands of load combinations and the acoustic noise level measured in decibels (dB).
Key technical criteria before choosing a PSU
Fan and acoustics: why do 140 mm fans matter compared with 120 mm?
Fan size determines thermal airflow and noise levels. The usual market standard uses 120 mm fans, which must spin at higher speeds to move the same volume of air (CFM). PSUs fitted with 140 mm fans can cool the chassis at lower revolutions per minute, reducing operating noise to as low as 12 dB, compared with the 20 dB or 25 dB typical of conventional units.
Internal components: why insist on 105 °C capacitors?
Electrolytic capacitors are the critical degradation point in any power conversion circuit. Standard 85 °C capacitors suffer premature wear under sustained load spikes. Units built with Japanese capacitors rated for 105 °C offer twice the tolerance to thermal cycles and extend the service life of the power delivery beyond 7 years.
Cable management and power connectors
Cable routing influences the overall cooling of the tower. Flat cables make routing easier in compact cases by taking up 40% less volume behind the motherboard tray, while extra-long cables avoid the need for extensions in full-size cases with bottom-mounted PSUs.
As for connectivity, current standards set strict capacities:
- 8-pin EPS: Delivers up to 235 W per connector to the CPU.
- 8-pin PCIe (6+2): Supplies up to 150 W per port to the graphics card.
- 12V-2x6: A 16-pin connector introduced in the PCIe CEM 5.1 and ATX 3.1 specifications that delivers up to 600 W, replacing the 12VHPWR design by shortening the sense pins to reduce the risk of poor contact if the plug is not fully inserted.
Common mistakes when buying a power supply
- Choosing on raw wattage alone: Buying a low-quality 850 W PSU often delivers less real power on the +12V rail than a reliable 650 W model with a proven certification.
- Mistaking the CE marking for a quality seal: Complying with the CE marking is a legal requirement for selling in European territory, not a badge of technical reliability.
- Sizing the PSU for 100% load: Power supplies hit their optimal efficiency point and lowest temperature between 40% and 60% of their total capacity.
Which power supply should you choose based on your usage profile?
To choose the right model within Tacens' Radix range, you need to size the power output and connectors according to the graphics card and processor installed:
Profile 1: High-end gaming PCs and workstations (850 W)
- Recommended model: Tacens Radix 1RECOX850.
- Technical justification: Designed for configurations with high-draw graphics cards. It offers 850 W of power, Japanese Toshin Kyogo capacitors rated at 105 °C for maximum thermal resilience, a 140 mm fan to keep noise emissions low, a weight of 1548 g, dimensions of 150x160x85 mm and ATX12V, CE, ROHS and TUV safety certifications. It features 2 PCIe 6+2 PIN connectors and 6 SATA connectors.
Profile 2: Upper mid-range gaming towers (750 W)
- Recommended model: Tacens Radix 1RECOX750.
- Technical justification: Suited to 8-core processors and dedicated GPUs of up to 250 W. It integrates 750 W of continuous power, a 140 mm fan, a 150x160x85 mm chassis weighing 1479 g, extra-long black flat cables that optimise airflow and ATX12V, CE, ROHS and TUV certifications.
Profile 3: Standard mid-range builds (650 W)
- Recommended model: Tacens Radix 1RECOX650.
- Technical justification: Covers systems with mid-range graphics cards connected via a single PCIe 6+2 PIN connector. It provides 650 W of power, a 1400 g chassis with a 140 mm fan and 4 SATA connectors for storage.
Profile 4: Advanced office PCs and tight budgets (550 W)
- Recommended model: Tacens Radix 1RECOX550.
- Technical justification: Delivers 550 W with ATX12V, CE, ROHS and TUV certification, a 1350 g chassis, a quiet 140 mm fan and extra-long flat cabling for tidy builds with no need for adapters.
Products mentioned

RADIX ECO X 850
| Weight | 1548g |
|---|---|
| Dimensions | 150x160x85mm |
| Certifications | ATX12V CE ROHS TUV |
| Connectors | /1x ATX MB 24 PIN /1x EPS +12V 4+4 PIN /2x PCIe 6+2 PIN /6x SATA /3x Molex 4 PIN |
| Extras | 105°C Japanese Toshin Kyogo capacitors |
| Colour | Black |

RADIX ECO X 750
| Weight | 1479g |
|---|---|
| Dimensions | 150x160x85mm |
| Certifications | ATX12V CE ROHS TUV |
| Connectors | /1x ATX MB 24 PIN /1x EPS +12V 4+4 PIN /2x PCIe 6+2 PIN /6x SATA /3x Molex 4 PIN |
| Extras | Black extra-long flat cables |
| Colour | Black |

RADIX ECO X 650
| Weight | 1400g |
|---|---|
| Dimensions | 150x160x85mm |
| Certifications | ATX12V CE ROHS TUV |
| Connectors | /1x ATX MB 24 PIN /1x EPS +12V 4+4 PIN /1x PCIe 6+2 PIN /4x SATA /2x Molex 4 PIN |
| Extras | Black extra-long flat cables |
| Colour | Black |

RADIX ECO X 550
| Weight | 1350g |
|---|---|
| Dimensions | 150x160x85mm |
| Certifications | ATX12V CE ROHS TUV |
| Connectors | /1x ATX MB 24 PIN /1x EPS +12V 4+4 PIN /1x PCIe 6+2 PIN /3x SATA /2x Molex 4 PIN |
| Extras | Black extra-long flat cables |
| Colour | Black |
FAQs about 80 PLUS and power supplies
Does an 80 PLUS Gold PSU always consume 92% of the energy?
No, the certification only guarantees 92% efficiency when the PSU is working at exactly 50% of its rated load at 230 V. At very low loads (below 10%) or at 100% of its maximum capacity, performance drops to figures between 85% and 89%.
Is it dangerous to use a PSU without 80 PLUS certification?
It is not inherently dangerous provided it meets the mandatory electrical standards, but it will dissipate more heat inside the case and push up your electricity bill. What is more, uncertified PSUs tend to use components with lower thermal tolerance, such as 85 °C capacitors.
Does stepping up from 80 PLUS Bronze to 80 PLUS Gold pay for itself?
Yes, on computers that run more than 4 hours a day with loads above 250 W. The jump from 88% (Bronze) to 92% (Gold) saves between €15 and €30 a year on the electricity bill, covering the price difference within the first two years.
The best: 80 PLUS Gold certification guarantees 92% efficiency at half load, reducing waste heat and saving more than €30 a year on the electricity bill.
The worst: The 80 PLUS label only audits energy efficiency at three fixed load points, without assessing electrical ripple or voltage regulation.
Buy it if: You want to cut electricity consumption and keep temperatures low with a 140 mm fan PSU and 105 °C Japanese capacitors.
Don't buy it if: Your machine draws less than 100 W for basic office tasks and will never recoup the price premium of a Gold-certified PSU.